Table of Contents
Advertisement
Radiator
Engine Coolant Refilling and Bleeding (cont'd)
8.
Mix the recommended antifreeze with an equal
amount of water in a clean container.
NOTE:
• Always use Genuine Honda Antifreeze/Coolant.
Using a non-Honda coolant can result in corro-
s\on, Caus\t'\9
tne
coo\\ng S"Istem \
0
ma.\\unct\on
or fail.
•
For best corrosion protection, the coolant con-
centration must be maintained year-round at
SOO
Io
minimum.
Coolant concentrations Jess than
50%
may not
provide sufficient protection against
corrosion or freezing. Coolant concentrations
greater than
60%
will impair cooling effi ciency
and are not recommended.
•
Do not use additional rust inhibitors or anti-rust
products; they may not be compatible with the
coolant.
Engine Coolant Refill Capacity (including 0.6
e
10.63
US qt. 0.53
Imp
qtl for heater and reservoir]:
A/T: 3.9 I 14.1 US
qt.
3.4
Imp
qtl
MIT: 4.0
e
14.2 US qt. 3.5
Imp
qtl
10-6
9. Pour coolant into the radiator up to the base of the
fil ler neck. When pouring engine coolant, do not let
cool ant spill on any electrical parts or the
paint.
If
any coolant
spills,
rinse
it
off immediately.
10.
Start the
engine,
and let
it
run until it warms up (the
rad iator fan comes on at least twice).
11
.
Turn off the
engine.
Ch eck the level in the
radiator,
add coolant if
needed.
12.
Put the radiator cap on tightly, then run the engine
again and check for leaks.
Advertisement
Table of Contents
Troubleshooting
