Honda CR-V 1997 Service Manual page 125

Timing Belt
Installation (cont'd)
3. Install the timing belt tightly in the sequence shown.
CD
Timing belt drive pulley (crankshaft)
->
®
Adjust-
ing pulley
--t
@ Water pump pulley
--t
@ Exhaust
camshaft pulley
--t
®
Intake camshaft pulley.
NOTE: Make sure the timing belt drive pulley and
camshaft pulleys are at TDC.
4. Loosen and retighten the adjusting bolt to tension
the timing belt.
5. Clean, then install the lower cover and middle
cover.
6. Install the crankshaft pulley, then tighten the pulley
bolt (see page 6-7).
7. Rotate the crankshaft pulley about five or six turns
counterclockwise so that the timing belt positions
on the pulleys.
8. Adjust the timing belt tension (see page 6-9).
6-12
9. Check that the crankshaft pulley and camshaft pulleys
a re both at TDC.
POINTER
..
·UP· MARKS
POINTER ON
. / '.D •• ER
COVER
TOCMARK
(Painted White)
POINTER
TOC MARKS TOC MARKS
POINTER
10. If the camshaft pulleys are not positioned at TDC,
remove the timing belt. adjust the position following
the procedure on page 6-1', then reinstall the timing
belt.
11. Install the cylinder head cover (see page 6-32).
12. After installation, adjust the tension on each belt.
• See section 4 for alternator belt tension adjust-
ment.
• See section 22 for
Ale
compressor belt tension
adjustment.
•
See section 17 for PIS pump belt tension adjust-
ment.