Honda CR-V 1997 Service Manual page 102

Engine Removal/Installation
Removal (cont'd)
17. Disconnect the power steering pressu re (PSP) switch
connector, and remove the wire harness clamp.
18. Remove the slave cylinder and clutch hose bracket
(MIT).
NOTE:
• Do not d isconnect the pipe/hose assembly.
• Do not operate the clutch pedal once the slave
cylinder has been removed.
• Take ca re not to bend the pipe/hose assembly.
5-6
'''.IJT[:H
HOSE
BRACt<ET
CYUNDER
19. Disconnect the transmission ground cable (MIT).
TRANSMISSION
GROUND
CABI.£
20. Remove th e cotter pins, then remove the steel
washers, plastic washers, shift cable. and select cable
from the levers (M/TI.
COTTERPW
Replace.
WASHER
SHIFT
CABlE
CABLE
COTTER PIN
STEEL
WASHER
WASHER
21 . Remove the cable bracket from the clutch housing
(M/TI.