Honda CR-V 1997 Service Manual page 144

7. Place the rocker arms on the pivots and the valve
stems. Put the rocker arms in their original posi-
tions.
8. Install the camshafts, then install the oil seals with
the open side (spring) facing in . Make sure that the
keyways on the camshafts are facing up and the No.
1 piston is at TOC.
ROCKER ARM
9. Clean and dry the cylinder head mating surfaces.
Apply liquid gasket (PI N 08718 - 0001 or 08718 -
0003) to the head mating surfaces of the No. 1 and
No. 6 camshaft holders on both the intake and
exhaust side.
NO. 6 No. I
m-- f < 9l - - H r-
EXHAUST
o
~~~ i~ ' -+_ -----~~_tr~r_-INTAKE
Apply liquid gasket to the shaded areas.
10. Install the camshaft holders.
NOTE:
• "I" or "E" marks are stamped on the camshaft
holders.
• The arrows marked on the camshaft holders
should point at the timing belt.
11 . Tighten each bolt in two steps to ensure that the
rockers do not bind on the valves.
12. Wipe off the excess liquid gasket from the No.1 and
No.6 camshaft holders with a shop towel.
Specified torque:
9.8
N·m (1.0 kgf·m, 7.2 Ibf·ft)
Apply engine oil to the bolt threads.
I
@
q>®
CD Q)
rID
@
~
~
~
Q
a
J p
INTAKE
,
~" 'Y
'r
Y,,'7
~r
cd
@
®
~
@
®
Q
rID @
EXHAUST
(cont'd)
6-31