Honda CR-V 1997 Service Manual page 150

Illustrated Index (cont'd)
NOTE: New rod bearings must be selected by matching connecting rod assembly and crankshaft identification markings
Isee pages 7-9),
....--.711
Lubricate all internal parts with engine oil
- II
during reassembly.
7-4
PISTON PIN
Removal, page 7-14
Installation. page 7-15
Inspection, page 7-16
CONNECTING ROD
End play, page 7-6
Selection, page 7·14
CONNECTING ROO
BEARINGS
Clearance, page 7-8
Selection. page 7-9
CONNECTING ROD BEARING CAP
Installation. page 7-20
NOTE: Install the caps so the
bearing recess is on the
sam e side as the recess
in the rod .
CONNECTING ROD CAP NUT
8xO.7Smm
31 N·m (3.2 kgf·m.
23 Ibf.ftl
Apply engine oil to the bolt threads . -
NOTE: After torquing each bearing
cap, rotate the crankshaft to check for
binding.
PISTON INSTALLAnON DIRECTION:
EXHAUST
INTAKE
Replacement, page 7-18
~ Measurement, page 7·17
Alignment, page 7· 18
I[]-
PlSTONRlNGS
~~'-
_ _ _ _ PISTON
Inspection, page 7-12
ENGINE BLOCK
Cytinder bore inspection, page 7-13
Warpage inspection, page 7-13
Inspect the top of each cylinder bore
for carbon build-up or a ridge
before removing the piston .
Remove the ridge jf necessary. page 7-10