Honda CR-V 1997 Service Manual page 168

Crankshaft
Installation (cont'd)
12. Apply liquid gasket to the oil pump mating surface
of the block.
13. Apply a light coat of oil to the crankshaft, the lip of
the seal, and the O-rings.
14. Apply grease to the lips of the oil seals.
15. Align the inner rotor with the crankshaft, then install
the oil pump. When the pump is in place, clean any
excess grease off the crankshaft, then check that the
oil seal lips are not distorted.
OIL SCREEN
DOWEL
O·RING
Repla ce .
Apply liqu id gasket along
the broken line.
8x 1.25mm
OIL PUMP
24 N·m 12.4 kgf'm,
17 Ibfof11
7-22
16. Apply liquid gasket on the oil pump and right side
cover mating areas.
o
o
CYLINDER
BLOCK
o
o
o
Apply liqu id gasket
to these points .
o 0
0
Lo;;-_-O ; ;---;:---r;::
RIGHT SIDE
COVER
o
0
0
Apply
liquid
gasket
to these points .
OIL PUMP
17. Install the oil pan gasket and oil pan. Wait no more
than five minutes after applying liquid gasket.
OIL PAN
OIL PAN
GASKET
Replace .