Honda CR-V 1997 Service Manual page 104

Engine Removal/lnstallation
Removal (cont'd)
31, Remove the shift cable. Take care not to bend the
cable when removing it. Always replace any kinked
cable with new one
(AfT) .
SNAP PIN
SMFT
CABlE
SHIFT CABlE
COVER
CONTROl. PIN
,
' \ 8.1.26mm
22
Nom
(22 kgf·m.
'Slb"'"
32. Remove the right damper fork Isee section 181.
33. Disconnect the suspension lower arm ball joints (see
section 18).
34. Remove the driveshafts (see section 16). Coat all
precision-finished surface with clean engine oil. Tie
plastic bags over the drives haft ends.
5-8
35. Make marks on the transfer companion flange and
propeller shaft as shown. Use these marks to set the
propeller shaft in the proper position when rein-
stalling 14WDI.
36. Remove the four bolts securing the propeller shaft,
then separate the propeller shaft from the transfer
companion flange 14WDI.
8x mm
32 N·m 13.3 kgl·m. 24 Ibf.f"
Replace.
37. Lower the hoist.