Unfused Image - Fuji Xerox Phaser 5500 Service Manual

Spots Troubleshooting Procedure (Continued)
Step Actions and Questions
3 Check the Drum Cartridge.
1. Install a new Drum Cartridge.
2. Print a Test Print.
Is the image density normal?
4 Check the Transfer Roller.
1. Remove the Transfer Roller.
2. Check for contamination or wear.
Is there contamination or wear?
5
Check the Heat and Pressure Roller.
WARNING:
Remove the Fuser.
Is there contamination or defects
on Heat or Pressure Roller?
6 Replace the Engine Logic Board
(page 8-89).
Print a Test Print.
Is the Test Print normal?

Unfused Image

The printed image is not fully fused to the paper. The image rubs off easily.
Initial Actions
Check to ensure that the printer installation meets environmental
specifications. A location that's too cold or too humid reduces fusing
performance.
Inspect the paper path for items, such as staples, paper clips, and paper
scraps.
Check to ensure that the paper is dry and within specifications.
Verify that the paper type is set correctly for the Fuser temperature
configuration.
5-30
Allow the Fuser to cool
before removing it.
Yes
Problem solved.
Go to Step 5.
Replace the Fuser
(page 8-76).
Problem solved.
Phaser 5500 Printer Service Manual
No
Go to Step 4.
Replace the Transfer
Roller (page 8-44).
Go to Step 6.
Replace the I/P Board
(page 8-91).