Jam At F Or G - F4-7N Top Tray Exit Snr On - Fuji Xerox Phaser 5500 Service Manual

Static Jam at H (No Paper Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
13
Test the Compile Tray No Paper Sensor.
Run the Service Diagnostics Compile Tray
No Paper Sensor test.
Does the sensor's state change?
14 Check the Compiler Harness connection.
Are P/J8359 and P/J8309 connected?
15 Print a Test Print.
Does the error still occur?
16 Check Compiler Harness continuity.
1. Disconnect P/J8359 and P/J8309.
2. Check for continuity at the following:
P/J8359-3 <=> P/J8309-1
P/J8359-2 <=> P/J8309-2
P/J8359-1 <=> P/J8309-3
Are these conductive?
17
Check for +5 V to the Compile Tray No
Paper Sensor.
Is there +5 V across J8309-3 <=> J8309-
1 on the Finisher Main PWB?
18 Check the Compile Tray No Paper Sensor)
signal.
Does the voltage across P8309-2 <=>
P8309-1 on the Finisher Main PWB
change when the sensor actuator is
moved?

Jam at F or G - F4-7n Top Tray Exit SNR ON

Paper does not reach the Stacker Upper Tray Exit Sensor on time.
Applicable Error Codes
Jam at F - F4-71 Top Tray Exit SNR ON Jam A
Jam at G - F4-73 Top Tray Exit SNR ON Jam B
Jam at G - F4-74 Top Tray Exit SNR ON Jam C
Error Messages, Codes, and Procedures
Yes
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 16.
Go to Step 16.
Go to Step 17.
Go to Step 18.
Replace the
Finisher Main
PWB
(page 3-248).
No
Go to Step 14.
Connect and go
to Step 15.
Problem solved.
Repair the
Compiler
Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Compile Tray No
Paper Sensor
(page 3-182).
3-123