Fuji Xerox Phaser 5500 Service Manual page 152

Jam at B (Registration Sensor) Troubleshooting Reference
Applicable Parts
Take Away Roller
Door J
Registration Sensor
Front Harness A
Engine Logic Board
Take Away Motor
Main Harness
Tray 6 PWB
Jam at B (Registration Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
Open Door J.
Are all the rollers installed correctly,
clean, and turn freely?
2 Check the printer paper path.
Open Door A.
Is the paper path clean?
3 Test the Registration Sensor.
1. Open Door A
2. Run the Service Diagnostics
Registration Sensor test.
Does the sensor change state?
4
Check the Registration Sensor connection
to the printer's Front Harness.
Are P/J104 and P/J403 connected to the
Registration Sensor?
5
Print a Test Print.
Does the error still occur?
6
Check the Harness for continuity.
1. Disconnect P/J104 and P/J403.
2. Check for continuity at the following:
J104-3 <=> J403B-3
J104-2 <=> J403B-8
J104-1 <=> J403B-13
Are these conductive?
3-74
References
Print Engine P/J Engine Logic Board (page 10-13)
PL4.5 Print Engine Registration (page 9-30)
PL5.1 Laser, CRU and Toner Dispense (page 9-32)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
2000-Sheet Tray 6 Feeder P/J Locator (page 5-20)
2000-Sheet Tray 6 Drive P/J Locator (page 5-21)
2000-Sheet Tray 6 Drive Wiring (page 5-25)
PL22.7 Drive and Transportation (page 4-30)
PL22.8 Tray 6 Electrical (page 4-32)
Phaser 5500 Printer Service Manual
Yes
Go to Step 2.
Go to Step 3.
Go to Step 9.
Go to Step 6.
Go to Step 6.
Go to Step 7.
No
Clean or replace
the Rollers.
Clean the paper
path.
Go to Step 4.
Connect and go
to Step 5.
Problem solved.
Repair the
printer's Front
Harness A.