Tray Paper Guide Does Not Match Size Menu -H4-3/4 - Fuji Xerox Phaser 5500 Service Manual

Tray Paper Guide Does Not Match Size Menu -H4-3/4

Applicable Error Codes
Tray Paper Guide Does Not Match Size Menu- H4-3 Tray 4 Paper Size Error
Tray Paper Guide Does Not Match Size Menu- H4-4 Tray 5 Paper Size Error
Paper Size Failure (Tray 4-5 Paper Size Switch) Troubleshooting Reference
Applicable Parts
Paper Size Switch
Tray Paper Guides
Tray 4-5 PWB
Engine Logic Board
Paper Size Failure (Tray 4-5 Paper Size Switch) Troubleshooting Procedure
Step Actions and Questions
1
Check the Paper in the affected tray.
Is paper loaded in the tray properly?
2 Check the tray paper guides.
Are the paper guides set correctly?
3 Check the Paper Size Switch for the
affected tray.
Is the switch installed correctly?
4 Test the Paper Size Switch for the affected
tray.
Run the Service Diagnostics Size Sensor
test for the affected tray.
Does the sensor state change each time
the loaded tray is moved in or out?
5 Check the Paper Size Switch connection.
For Tray 4:
Are P/J820 and P/J548 connected?
For Tray 5:
Are P/J824 and P/J548 connected?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet Feeder P/J Locator (page 5-5)
1000-Sheet Feeder P/J Electrical (page 5-6)
1000-Sheet Tray 4 & 5 Wiring (page 5-9)
PL20.2 Tray (1/2) Feeder (1/2) (page 4-6)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Reconnect the
connector of the
Engine Logic
Board.
Go to Step 6.
No
Reload the paper.
Set the guides
properly.
Correct the
installation.
Go to Step 5.
Connect the
Paper Size
Switch.
3-157