Fuji Xerox Phaser 5500 Service Manual page 294

Paper Size Mismatch in Tray 4 or 5 Troubleshooting Procedure (Continued)
Step Actions and Questions
11 Check the tray's rollers.
Remove the tray.
Is the Feed, Retard or Nudger Roller
worn or contaminated?
12 Check paper jam position.
Open Door A.
Does the paper touch the Registration
Sensor?
13 Check the Take Away Roller.
Open Door C.
Is the Take Away Roller worn or
contaminated?
14 Check the Registration Roller.
Open Door A.
Is the Registration Roller worn or
contaminated?
15 Test the Registration Sensor.
1. Run the Service Diagnostics
Registration Sensor test.
2. Open Door A.
Does the sensor status change when
the actuator is moved?
16 Check the Registration Sensor connection.
Are J104 and J403B connected?
17 Check continuity between the Registration
Sensor and Engine Logic Board.
Is there continuity on each wire
between J104 <=> J403?
18
Check for +5 V to the Registration Sensor.
Is there +5 V across J403-B13 (+) <=>
ground?
19
Test the Registration Clutch.
Run the Service Diagnostics Registration
Clutch test.
Does the Registration Clutch operate?
20
Check Registration Clutch connections.
Are P215 and P/J403 connected?
21 Check continuity between the Registration
Clutch and Engine Logic Board.
Is there continuity on each wire
between P215 <=> P/J403?
3-216
Yes
Go to Step 12.
Remove the paper
and go to Step 15.
Clean or replace
the Take Away
Roller.
Clean or replace
the rolls.
Go to Step 19.
Go to Step 17.
Go to Step 18.
Replace the
Registration
Sensor
(page 8-52).
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 21.
Go to Step 22.
Phaser 5500 Printer Service Manual
No
Clean or replace
the affected roller.
Go to Step 13.
Go to Step 14.
Go to Step 15.
Go to Step 16.
Connect J104
and J403.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 20.
Connect P215
and P/J403.
Repair the wiring.