Tray 6 Logic Board Failure - H6-7 Hcf Comm Failure - Fuji Xerox Phaser 5500 Service Manual

Tray 6 Comm Error Troubleshooting Procedure (Continued)
Step Actions and Questions
2 Check the Tray 6 PWB connections.
Are the connectors connected to the
PWB?
3 Cycle printer power.
Does the error still occur?
4 Disconnect all the connectors connected to
the Tray 6 PWB and reconnect them.
Cycle printer power.
Does the error still occur?

Tray 6 Logic Board Failure - H6-7 HCF Comm Failure

A communications error occurred between Tray 6 and the Engine Logic Board.
Applicable Error Code
Tray 6 Logic Board Failure - H6-7 HCF Comm Failure
Tray 6 Comm Error Troubleshooting Reference
Applicable Parts
Tray 6 PWB
Engine Logic
Board
Tray 6 NVRAM Error Troubleshooting Procedure
Step Actions and Questions
1 Check the Tray 6 installation.
Is Tray 6 installed correctly?
2
Cycle printer power.
Does the error still occur?
3
Check the Tray 6 PWB connections.
Are P/J800A, P/J800B, P/J800 and P/
J414 connected?
3-188
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
2000-Sheet Tray 6 Drive P/J Locator (page 5-21)
2000-Sheet Tray 6 Drive Wiring (page 5-25)
PL22.8 Tray 6 Electrical (page 4-32)
Phaser 5500 Printer Service Manual
Yes
Go to Step 4.
Go to Step 4.
Replace the Tray 6
PWB (page 3-67).
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
No
Connect and go
to Step 3.
Problem solved.
Problem solved.
No
Correct the
installation. If
problem persists,
go to Step 2.
Problem solved.
Connect and go
to Step 4.