Stacker Lower Tray Failure - H5-86 Side Regi Snr Off - Fuji Xerox Phaser 5500 Service Manual

Eject Clamp (Set Clamp Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
18
Check Set Clamp Clutch Harness
continuity.
1. Disconnect P/J8338B and P/J8304.
2. Check for continuity at the following:
J8338B-1 <=> P/J8304-20
J8338B-2 <=> P/J8304-22
Are these conductive?
19 Check for +24 V to the Set Clamp Clutch.
Is there +24 V across J8304-22 <=>
ground on the Finisher Main PWB?
20 Replace the Set Clamp Clutch.
Print a Test Print.
Does the error still occur?

Stacker Lower Tray Failure - H5-86 Side Regi SNR OFF

Either or both Side Registration Sensors do not transition within the time interval
specified (500 ms) following activation of the Punch Move Motor or the state changes
to On after the Punch Move Motor stops.
Applicable Error Code
Stacker Lower Tray Failure - H5-86 Side Regi SNR OFF
Punch Failure (Side Registration Sensors) Troubleshooting Reference
Applicable Parts
Punch Move Motor
Punch Drive Harness
Finisher Main PWB
Engine Logic Board
Side Registration
Sensors
Punch Sensor
Harness
Punch Unit Harness
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Punch P/J Locator (page 5-31)
Finisher Punch (1/2) Wiring (page 5-46)
Finisher Punch (2/2) Wiring (page 5-47)
PL8.1 Print Engine Electrical (page 9-40)
PL25.7 Finisher Punch (page 4-56)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 19.
Go to Step 20.
Replace the
Finisher Main
PWB
(page 3-248).
No
Repair the Set
Clamp Clutch
Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
3-181