Jam At Tray 1/Mpt - C9-3 Tray 1/Mpt - Fuji Xerox Phaser 5500 Service Manual

Jam at D (Wait Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
Open Door D.
Does the paper touch the sensor?
2
Test the Wait Sensor.
Run the Service Diagnostics Duplex Unit
Wait Sensor test.
Does the sensor change state?
3 Check the Wait Sensor connection.
Are P/J123 and P/J541 connected?
4
Check continuity between the Wait Sensor
and Duplex Unit PWB.
Is there continuity on each wire
between P/J123 <=> P/J541?
5 Check for +5 V to the Wait Sensor.
Is there +5 V across P/J123-3 (+) <=>
ground?
6 Check continuity between the Duplex Unit
PWB and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417?
7 Check for +5 V to the Duplex Unit PWB.
Is there +5 V across P/J541-1 (+) <=>
ground?

Jam at Tray 1/MPT - C9-3 Tray 1/MPT

Paper fed from Tray 1/MPT did not reach the Registration Sensor, located behind
Door A, on time.
Applicable Error Code
Jam at Tray 1/MPT - C9-3 Tray 1/MPT
3-84
Yes
Remove the
paper.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 4.
Go to Step 5.
Replace the Wait
Sensor
(page 3-78).
Go to Step 7.
Replace the
Duplex Unit PWB
(page 3-77).
Phaser 5500 Printer Service Manual
No
Go to Step 2.
Go to Step 3.
Connect the
sensor.
Repair the wiring.
Go to Step 6.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).