Stapler Failure - H5-9N Move Snr - Fuji Xerox Phaser 5500 Service Manual

Stapler Failure (Stapler Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
6
Check the Staple Harness connections.
Are P/J8356 and P/J8308 connected?
7 Staple a Test Print.
Does the error still occur?
8 Check Staple Harness continuity.
1. Disconnect P/J8356 and P/J8308.
2. Check for continuity at the following:
P/J8356-1 <=> P/J8308-15
P/J8356-2 <=> P/J8308-14
P/J8356-3 <=> P/J8308-13
P/J8356-4 <=> P/J8308-12
P/J8356-5 <=> P/J8308-11
Are these conductive?
9 Replace the Stapler Assembly.
Staple a Test Print.
Does the error still occur?
10 Replace the Finisher Main PWB.
Does the error still occur?

Stapler Failure - H5-9n Move SNR

The Staple Move Position Sensor does not change state in the specified time interval
after the Stapler Head starts moving toward or reaching the staple position. This error
also occurs if the Stapler Move Position Sensor is turned OFF again after being ON
and the Stapler Head is stopped.
Applicable Error Codes
Stapling Failure - H5-95 Move SNR ON
Stapling Failure - H5-96 Move SNR OFF
Stapler Failure (Staple Move Position Sensor) Troubleshooting Reference
Applicable Parts
Stapler Lower Carriage
Move Home Position
Sensor
Stapler Harness
Finisher Main PWB
Error Messages, Codes, and Procedures
Yes
Go to Step 8.
Go to Step 8.
Go to Step 9.
Go to Step 10.
Replace the
Engine Logic
Board
(page 8-89).
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Staple P/J Locator (page 5-30)
Finisher Stapler Wiring (page 5-45)
PL25.8 Finisher Staple (page 4-58)
PL25.14 Finisher Electrical (page 4-70)
No
Connect and go
to Step 7.
Problem solved.
Repair the Staple
Harness.
Problem solved.
Problem solved.
3-185