Fuji Xerox Phaser 5500 Service Manual page 191

Jam at F or G (Compile Exit Sensor ON) Troubleshooting Procedure (Continued)
Step Actions and Questions
6
Print a Test Print.
Does the error still occur?
7 Check Buffer Sensor Harness continuity.
1. Disconnect P/J8392 and P/J8318.
2. Check for continuity at the following:
P/J8392-3 <=> J8318B-1
P/J8392-2 <=> J8318B-2
P/J8392-1 <=> J8318B-3
Are these conductive?
8 Check Main Sensor Harness continuity.
1. Disconnect P/J8318 from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8318A-3 <=> P/J8302A-13
J8318A-2 <=> P/J8302A-14
J8318A-1 <=> P/J8302A-15
Are these conductive?
9 Check for +5 V to the Buffer Path Sensor.
Is there +5 V across J8302A-15 <=>
J8302A-13 on the Finisher Main PWB?
10 Check the Buffer Path Sensor signal.
Does the voltage across P8302A-14 <=>
P8302A-13 on the Finisher Main PWB
change when the actuator is operated?
11 Test the Registration Motor.
Run the Service Diagnostics Registration
Motor CCW Test.
Does the motor rotate normally?
12 Test the Buffer Roller Drive.
Run the Service Diagnostics Registration
Motor CCW test.
Does the Buffer Roller rotate?
13 Print a Test Print.
Does the error still occur?
14
Check the Registration Motor harness
connections.
Are P/J8335 and P/J8304 connected?
15
Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
Yes
Go to Step 7.
Go to Step 8.
Go to Step 9.
Go to Step 10.
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 20.
Go to Step 14.
Go to Step 14.
Go to Step 16.
Go to Step 16.
No
Problem solved.
Repair the Buffer
Sensor Harness.
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Buffer Path
Sensor
(page 3-207).
Go to Step 12.
Restore operation
and go to
Step 13.
Problem solved.
Connect and go
to Step 15.
Problem solved.
3-113