Jam At D And A - C6-2 Duplex Area Jam - Fuji Xerox Phaser 5500 Service Manual

C6-1 Duplex Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions
9
Check the Duplex Motor for continuity.
Is there continuity on each wire
between P/J212 <=> P/J542?
10 Check for +24 V to the Duplex Motor.
Is the +24 V across P/J212-5 (+) <=>
ground?
11 Check the Duplex PWB connection.
Are P/J540 and P/J417 connected?
12 Check continuity between the Duplex PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417?
13 Check for +24 V to the Duplex PWB.
Is there +24 V across P/J540-2 (+) <=>
ground?
14 Test the Registration Sensor.
Run the Service Diagnostics Registration
Sensor test.
Does the sensor status change?
15 Check the Registration Sensor connection.
Are P/J104 and P/J403B connected?
16
Check continuity between the Registration
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J104 <=> P/J409B?
17
Check for +5 V to the Registration Sensor.
Is there +5 V across P/J104-1 (+) <=>
ground?
18
Check continuity between the Duplex PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417?
19 Check for +5 V to the Duplex PWB.
Is there +5 V across P/J540-1 (+) <=>
ground?

Jam at D and A - C6-2 Duplex Area Jam

Paper being fed from the Duplex Unit did not reach the Registration Sensor, located
on behind Door A, on time. Paper didn't stop at the Wait Sensor.
Error Messages, Codes, and Procedures
Yes
Go to Step 10.
Go to Step 14.
Go to Step 12.
Go to Step 13.
Replace the
Duplex PWB
(page 3-77).
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 16.
Go to Step 17.
Replace the
Registration
Sensor
(page 8-52).
Go to Step 19.
Replace the
Duplex PWB
(page 3-77).
No
Repair the wiring.
Go to Step 11.
Connect P/J540
and P/J417.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 15.
Connect P/J104
and P/J403B.
Repair the wiring.
Go to Step 18.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
3-53