Paper Size Jam - Paper Size In Tray 4 Or 5 - Fuji Xerox Phaser 5500 Service Manual

Paper Size Jam - Paper Size in Tray 4 or 5

Paper size mismatch in either Tray 4 or 5.
Note
Custom size papers loaded in the tray must match the custom size paper selected
at the Front Panel or from the print driver.
Paper Size Mismatch in Tray 4 or 5 Troubleshooting Reference
Applicable Parts
Paper Size Switch
Front Size Guide
Rear Side Guide
Registration Sensor
Registration Clutch
Tray 4-5 PWB
Engine Logic Board
Paper Size Mismatch in Tray 4 or 5 Troubleshooting Procedure
Step Actions and Questions
1 Check for paper.
Is paper loaded in the selected tray?
2 Check the tray's paper size guides.
Are the paper size guides set correctly?
3
Check Paper Size Switch installation.
Is the Paper Size Switch installed
correctly?
4 Test the Paper Size Switch.
Run the Service Diagnostics Paper Size
Switch test for the affected tray.
Does the paper size displayed match
the paper size in the tray?
5 Check the Paper Size Switch connections.
For Tray 3:
Are P/J820 and P/J548 connected?
For Tray 4:
Are P/J824 and P/J548 connected?
3-214
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine P/J Registration Transport (page 10-10)
Print Engine Registration Transport Wiring (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet P/J Tray 4 & 5 Electrical (page 5-6)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Phaser 5500 Printer Service Manual
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 11.
Go to Step 6.
No
Load paper.
Set the guides
properly.
Correct the
installation.
Go to Step 5.
Connect the
switch.