Jam At F Or Stacker Upper Tray - F4-7Ntop Tray Snr Off - Fuji Xerox Phaser 5500 Service Manual

Jam at F or G (Stacker Upper Tray Exit Sensor ON) Troubleshooting Procedure
Step Actions and Questions
15 Check Main Sensor Harness continuity.
1. Disconnect P/J8312 from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8312A-3 <=> P/J8302A-7
J8312A-2 <=> P/J8302A-8
J8312A-1 <=> P/J8302A-9
Are these conductive?
16 Check for +5 V to the Upper Tray Exit
Sensor.
Is there +5 V across J8302A-9 <=>
J8302A-7 on the Finisher Main PWB?
17 Check the Upper Tray Exit Sensor signal.
Does the voltage across P8302A-8 <=>
P8302A-7 on the Finisher Main PWB
change when sensor is actuated?

Jam at F or Stacker Upper Tray - F4-7nTop Tray SNR OFF

Paper does not leave the Stacker Upper Tray Exit Sensor on time.
Applicable Error Codes
Jam at F - F4-72 Top Tray Exit SNR OFF Jam A
Jam at Stacker Upper Tray - F4-75 Top Tray Exit SNR OFF Jam B
Jam at F or Upper Tray (Exit Sensor OFF) Troubleshooting Reference
Applicable Parts
Transport Roller
Pinch Roller
Transport Motor
Main Drive Harness
Finisher Main PWB
Top Exit Sensor Harness
Main Sensor Harness
Top Exit Sensor
3-126
Yes
Go to Step 16.
Go to Step 48.
Replace the
Finisher Main
PWB
(page 3-248).
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Phaser 5500 Printer Service Manual
No
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Upper Tray Exit
Sensor
(page 3-226).