Jam At A - E1-6 Regi Area Jam - Fuji Xerox Phaser 5500 Service Manual

E1-2 Regi Area Jam (Fuser Exit Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
3 Test the Fuser Exit Sensor.
1. Open Door A.
2. Run the Service Diagnostics Fuser Exit
Sensor test.
Does the sensor change state?
4 Check the Fuser Exit Sensor connection.
Are P/J125 and P/J410 connected?
5 Check continuity between the Fuser Exit
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J125 <=> P/J410?
6
Check for +5 V at the Fuser Exit Sensor.
Is there +5 V across the sensor
connector's P/J125-3 <=> ground?
7 Test the Registration Clutch operation.
Run the Service Diagnostics Registration
Clutch test.
Does the clutch operate properly?
8
Check the Registration Clutch connection.
Are P/J215 and P/J403B connected?
9
Check continuity between the Registration
Clutch and Engine Logic Board.
Is there continuity on each wire
between P/J215 <=> P/J403B?
10 Check for +24 V to the Registration Clutch.
Is there +24 V across P215-2 (+) <=>
ground?
11
Check Registration Clutch resistance.
Is the resistance between J215-1 and
J215-2 approximately 240 ohms?

Jam at A - E1-6 Regi Area Jam

Paper remains at the Registration Sensor located behind Door A.
Applicable Error Code
Jam at A - E1-6 Regi Area Jam
3-38
Yes
Go to Step 7.
Go to Step 5.
Go to Step 6.
Replace the Fuser
Exit Sensor
(page 8-77)
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 9.
Go to Step 10.
Go to Step 11.
Replace the
Engine Logic
Board
(page 8-89).
Phaser 5500 Printer Service Manual
No
Go to Step 4.
Connect the
sensor.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 8.
Connect P/J215
and P/J403B.
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
Replace
Registration
Clutch
(page 8-51).