Fuji Xerox Phaser 5500 Service Manual page 159

Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Procedure (Continued)
Step Actions and Questions
10
Test the Feed Out Sensor #6.
1. Open Door J.
2. Run the Service Diagnostics Tray 6
Feed Out Sensor test.
Does the sensor change state?
11 Check the Feed Out Sensor #6
connections.
Is PF67 and JF54 connected?
12 Check the Main Harness connections.
Is PF54 and JF01 connected?
13 Print a Test Print.
Does the error still occur?
14
Check the Harness for continuity.
1. Disconnect PF67 and JF54.
2. Check for continuity at the following:
PF67-1 <=> JF54-3
PF67-2 <=> JF54-2
PF67-3 <=> JF54-1
Are these three conductive?
15 Check the Main Harness continuity.
1. Disconnect PF54 and JF01.
2. Check for continuity at the following:
JF54-1 <=> JF01-3
JF54-2 <=> JF01-2
JF54-3 <=> JF01-1
Are these three conductive?
16 Check for +5 V to the Feed Out Sensor #6.
Is there +5 V across PF01-3 <=> PF04-2
on the Tray 6 PWB?
17 Check the Feed Out Sensor #6 signal.
Does the voltage across JF01-2 <=>
PF04-2 on the Tray 6 PWB change when
the Feed Out Sensor is actuated?
18 Test the Tray 6 Feed/Lift Motor.
Run the Service Diagnostics Feed Motor
test.
Does the Feed Motor rotate normally?
19 Check the harness connections.
Are PF58 and PF56 on the Feeder and
Main Harnesses, and JF06 on the PWB
connected?
20 Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
Yes
Go to Step 18.
Go to Step 12.
Go to Step 14.
Go to Step 14.
Go to Step 15.
Go to Step 16.
Go to Step 17.
Go to Step 33.
Go to Step 26.
Go to Step 21.
Go to Step 21.
No
Go to Step 11.
Connect and go
to Step 12.
Connect and go
to Step 13.
Problem solved.
Repair the
Harness.
Repair the Main
Harness.
Replace the Tray
6 PWB
(page 3-67).
Replace the Feed
Out Sensor #6
(page 3-63).
Go to Step 19.
Connect and go
to Step 20.
Problem solved.
3-81