Fuji Xerox Phaser 5500 Service Manual page 197

Jam at H (Compile Tray No Paper Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
7 Test the Eject Motor.
Run the Service Diagnostics Eject Motor
Low Speed Forward and Reverse tests.
Does the Eject Motor rotate properly?
8 Check Main Drive Harness connections.
Are P/J8336 and P/J 8304 connected?
9 Print a Test Print.
Does the error still occur?
10
Check Eject Motor Main Drive Harness
continuity.
1. Disconnect P/J8336 and P/J 8304.
2. Check for continuity at the following:
P/J8336-1 <=> P/J8304-15
P/J8336-2 <=> P/J8304-12
P/J8336-3 <=> P/J8304-17
P/J8336-4 <=> P/J8304-19
P/J8336-5 <=> P/J8304-14
P/J8336-6 <=> P/J8304-21
Are these conductive?
11 Check Eject Motor resistance.
Is there some amount of resistance
across P8336-2/5(COM) <=> P8336-1/3/
4/6?
12
Check for +24 V to the Eject Motor.
Is there +24 V across P/J8304-12 <=>
ground, and P/J8304-14 <=> ground on
the Finisher Main PWB?
13
Replace the Eject Bracket Assembly.
Print a Test Print.
Does the error still occur?
14 Test the Compile Exit Sensor.
Run the Service Diagnostics Compile Exit
Sensor test.
Does the sensor state change?
15
Check the Compile Exit Sensor
connection.
Are P/J8320 and P/J8391 connected?
16 Print a Test Print.
Does the error still occur?
17 Check Main Sensor Harness connections.
Are P/J8391 and P/J8302A connected?
18 Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
Yes
Go to Step 14.
Go to Step 10.
Go to Step 10.
Go to Step 11.
Go to Step 12.
Go to Step 13.
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 23.
Go to Step 17.
Go to Step 17.
Go to Step 18.
Go to Step 19.
No
Go to Step 8.
Connect and go
to Step 9.
Problem solved.
Repair the Main
Drive Harness.
Replace the Eject
Bracket Assembly
(page 3-187).
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
Go to Step 15.
Connect and go
to Step 16.
Problem solved.
Connect and go
to Step 18.
Problem solved.
3-119