Fuji Xerox Phaser 5500 Service Manual page 177

Static Jam at F (Transport Entrance Sensor) Troubleshooting Reference
Applicable Parts
X'port Entrance Sensor
Harness Main SNR
Harness Ent. Sensor
Harness Main Drive
Finisher Main PWB
Transport Motor
Static Jam at F (Transport Entrance Sensor) Troubleshooting Procedure
Step Actions and Questions
1
Test the H-'Xport Entrance Sensor.
1. Open Door F.
2. Run the Service Diagnostic H-'Xport
Entrance Sensor test.
Does the sensor change state?
2 Check the Sensor Harness connections.
Is the harness connected to the sensor
and Finisher correctly?
3 Print a Test Print.
Does the error still occur?
4 Check Sensor Harness continuity.
1. Disconnect P/J8319 and P/J8303B.
2. Check for continuity at the following:
J8319-3 <=> J8303B-1
J8319-2 <=> J8303B-2
J8319-1 <=> J8303B-3
Are these conductive?
5
Check Main Sensor Harness continuity.
1. Disconnect P/J8303A on the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8303A-3 <=> J8302A-1
J8303A-2 <=> J8302A-2
J8303A-1 <=> J8302A-3
Are these conductive?
6
Check for +5 V to the Entrance Sensor.
Is there +5 V across J8302A-3 <=>
J8302A-1 on the Finisher Main PWB?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 8.
Go to Step 4.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Go to Step 7.
No
Go to Step 2.
Connect and go
to Step 3.
Problem solved.
Repair the
Sensor Harness.
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
3-99