Take Away Clutch - Fuji Xerox Phaser 5500 Service Manual

Take Away Clutch

1.
Remove the I/P Board Cover (page 8-14).
2.
Remove the Upper Rear Cover (page 8-15).
PL4.5.14
3. Remove the screws securing the Take Away Clutch Bracket to the frame and
Motor Assembly and remove the bracket.
4.
Disconnect the Take Away Clutch connector from the harness.
5.
Remove the E-clip securing the Take Away Clutch and remove the Clutch.
Replacement Note
Make sure the notch in the clutch fits over the protrusion.
FRU Disassembly
Notch
E-Ring
Protrusion
Take Away Bracket
Take Away Clutch
Rear
s5500-599
8-53