Tray Empty - No Paper In Tray 2 Or 3 - Fuji Xerox Phaser 5500 Service Manual

Drum End of Life (Drum CRUM) Troubleshooting Procedure (Continued)
Step Actions and Questions
4 Check continuity between the Drum
Cartridge CRUM PWB and Engine Logic
Board.
1. Disconnect P126 and P/J419.
2. Check for continuity at the following:
P126-6 <=> P/J419-1
P126-5 <=> P/J419-2
P126-4 <=> P/J419-3
P126-3 <=> P/J419-4
P126-2 <=> P/J419-5
Are these conductive?
5
Check +5 V to the Drum Cartridge CRUM
PWB.
Is there +5 V across P126-6 (+) <=>
ground?

Tray Empty - No Paper in Tray 2 or 3

No paper is detected in either Tray 2 or 3.
No Paper in Tray 2 or 3 (No Paper Sensor) Troubleshooting Reference
Applicable Parts
No Paper Sensor
Engine Logic Board
No Paper in Tray 2 or 3 (No Paper Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check for paper.
Is paper loaded in the selected tray?
2 Test the No Paper Sensor.
Run the Service Diagnostics No Paper
Sensor test for the affected tray.
Does the sensor state change when the
sensor is blocked?
3-208
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Tray 2 & 3 Wiring (page 10-26)
PL2.3 Feeder (2/2) (page 9-12)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Service Manual
Yes
Go to Step 5.
Replace the Drum
Cartridge CRUM
PWB (page 8-70).
Yes
Go to Step 2.
Replace the
Engine Logic
Board
(page 8-89).
No
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
No
Load paper.
Go to Step 3.