Adjusting Fuser Temperature - Fuji Xerox Phaser 5500 Service Manual

Adjusting Fuser Temperature

Four temperature settings, listed in the following table, are available for each paper
type supported by the printer. The default fuser temperature setting for each paper
type is also noted. See "Fuser" on page 2-21 for additional information on Fuser
temperature settings.
Front Panel Fuser Temperature Modes by Paper Type
Paper Type
Low
Plain, Plain Paper
Letterhead, Mode 1
Colored,
Special
Transparency Transparency
Paper Mode
(Default)
Labels Plain Paper
Mode 1
Card Stock, Plain Paper
Envelopes Mode 2
Prepunched Plain Paper
Mode 2
To change the Fuser setting for a particular paper type:
1. From the Main menu, select
2. Select Paper Handling
3. Fuser
Select
4. Select Temperature for [paper
5. Select a temperature setting from the four available, then press the OK button to
place a check mark by that setting.
Note
You must scroll up to see the Extra High setting.
6. Select Exit, then press the OK button.
6-8
Medium
Plain Paper
Mode 1 (Default)
Plain Paper
Mode 2
Thick Paper
Mode 1
Plain Paper
Mode 1
Plain Paper
Mode 1 and
(Default)
Printer
Setup, then press the OK button.
Configuration, then press the OK button.
Temperature
High
Thick Paper
Mode 1
Plain Paper
Mode 1
Thick Paper
Mode 4 (Default)
Thick Paper
Mode 1 (Default)
Thick Paper
Mode 1
Setup, then press the OK button.
type], then press the OK button.
Phaser 5500 Printer Service Manual
Extra High
Thick Paper
Mode 2
Thick Paper
Mode 1
Thick Paper
Mode 2
Thick Paper
Mode 2
Thick Paper
Mode 2