Fuji Xerox Phaser 5500 Service Manual page 194

Static Jam at H (Compile Exit Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Test the Compile Exit Sensor.
Run the Service Diagnostics Compile Exit
Sensor test.
Does the sensor state change?
2 Check the Compile Exit Sensor
connection.
Are P/J8320 and P/J8391 connected?
3 Print a Test Print.
Does the error still occur?
4
Check Main Sensor Harness connections.
Are P/J8391 and P/J8302A connected?
5 Print a Test Print.
Does the error still occur?
6 Check Compiler Harness continuity.
1. Disconnect P/J8320 and P/J8391.
2. Check for continuity at the following:
P/J8320A-3 <=> J8391B-1
P/J8320A-2 <=> J8391B-2
P/J8320A-1 <=> J8391B-3
Are these conductive?
7 Check Main Sensor Harness continuity.
1. Disconnect P/J8391 from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8391A-3 <=> P/J8302A-4
J8391A-2 <=> P/J8302A-5
J8391A-1 <=> P/J8302A-6
Are these conductive?
8 Check for +5 V to the Compile Exit Sensor.
Is there +5 V across J8302A-6 <=>
J8302A-4 on the Finisher Main PWB?
9 Check Compile Exit Sensor signal.
Does the voltage across P8302A-5 <=>
P8302A-4 on the Finisher Main PWB
change when the actuator is operated?
10 Test the Exit Motor.
Run the Service Diagnostics Finisher Exit
Motor Test.
Does the motor rotate normally?
3-116
Yes
Go to Step 10.
Go to Step 4.
Go to Step 4.
Go to Step 6.
Go to Step 6.
Go to Step 7.
Go to Step 8.
Go to Step 9.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Finisher Main
PWB
(page 3-248).
Phaser 5500 Printer Service Manual
No
Go to Step 2.
Connect and go
to Step 3.
Problem solved.
Connect and go
to Step 5.
Problem solved.
Repair the
Compiler
Harness.
Repair the Main
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Buffer Path
Sensor
(page 3-207).
Go to Step 11.