Fuji Xerox Phaser 5500 Service Manual page 382

Spot Deletions Troubleshooting Procedure
Step Actions and Questions
1 Check paper condition.
1. Load fresh, dry paper.
2. Print a Test Print.
Does the problem still occur?
2 Check the paper path.
Check the paper path for
contamination or obstacles.
Is the paper path clear?
3 Check the Drum Cartridge.
1. Install a new Drum Cartridge.
2. Re-print the defective image.
Is the image density normal?
4 Checking the Transfer Roller.
1. Remove the Transfer Roller.
2. Check the Transfer Roller for
contamination and wear.
Is there any contamination or
wear on the Transfer Roller?
5
Check the Heat and Pressure Roller.
WARNING:
Remove the Fuser.
Is there contamination or defects
on the Heat or Pressure Roller?
6 Check the Engine Logic Board.
1. Replace the Engine Logic Board
(page 8-89).
2. Print a Test Print.
Is the trouble rectified?
5-36
Allow the Fuser to cool
before removing it.
Yes
Go to Step 2.
Go to Step 3.
Problem solved.
Replace the
Transfer Roller
(page 8-44).
Replace the Fuser
(page 8-76).
Problem solved.
Phaser 5500 Printer Service Manual
No
Problem solved.
Remove obstacles or
contamination.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Replace the I/P Board
(page 8-91).