Jam At E - E8-2 Duplex Area Jam - Fuji Xerox Phaser 5500 Service Manual

E4-6 Exit 2 Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions
9
Check continuity between the Exit PWB
and LVPS.
Is there continuity on each wire
between P/J430 <=> P/J526?
10 Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground?

Jam at E - E8-2 Duplex Area Jam

Paper being fed into the Duplex Unit did not reach the Wait Sensor on time.
Applicable Error Codes
Jam at E - E8-2 Duplex Area Jam
E8-2 Duplex Area Jam Troubleshooting Reference
Applicable Parts
Duplex Wait Sensor
Exit 2 Motor
Exit 2 OCT Roller
Exit 2 FU Roller
Exit 2 Inv Roller
Exit PWB
Duplex Unit PWB
Engine Logic Board
LVPS
E8-2 Duplex Area Jam Troubleshooting Procedure
Step Actions and Questions
1 Check paper position at Door E.
Does paper remain in Exit 2?
2 Check the FU Roller.
Is the FU Roller worn or contaminated
with paper dust?
3
Check the drive transmission.
Does the FU Roller and gears rotate
smoothly?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Exit 1 Wiring (page 10-30)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Exit 2 Plug/Jack Locator (page 5-15)
Exit 2 General Wiring (page 5-7)
Duplex Unit Plug/Jack Locator (page 5-12)
Duplex Unit Wiring (page 5-13)
PL23.1 Duplex Unit (page 4-34)
PL24.1 Exit 2 L/H Upper Chute (page 4-38)
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
Yes
Go to Step 10.
Replace the Exit
PWB (page 8-88).
Yes
Remove the
paper.
Clean or replace
the FU Roller.
Go to Step 4.
No
Repair the wiring.
Replace the
LVPS
(page 8-92).
No
Go to Step 2.
Go to Step 3.
Restore proper
operation.
3-49