Jam At Tray 6 - C5-1 Tray 6 - Fuji Xerox Phaser 5500 Service Manual

Jam at Tray 6 - C5-1 Tray 6

Paper fed from the 2000-Sheet Feeder did not reach Feed Out Sensor #6, located in
the Lower Feeder Assembly under Door J, on time.
Applicable Error Code
Jam at Tray 6 - C5-1 Tray 6
Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Reference
Applicable Parts
Feed Roller
Nudge Roller
Retard Roller
Feeder Harness
Main Harness
Tray 6 PWB
Pre-Feed Sensor
Feeder Motor
Nudger Solenoid
Engine Logic Board)
Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
1. Open Door J.
2. Open the Upper Feeder Assembly.
Are the Rollers installed correctly,
clean, and turn freely?
2 Test the Tray 6 Pre-Feed Sensor.
1. Open Door J.
2. Open the Upper Feeder Assembly.
3. Run the Service Diagnostics Tray 6
Pre-Feed Sensor test.
Does the sensor change state?
3
Check the Feeder Harness for connection.
Are PF61 and PF56B connected?
4
Check the Main Harness for connection
Are PF56B and JF02 connected?
5 Print a Test Print.
Does the error still occur?
3-68
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
2000-Sheet Tray 6 Feeder P/J Locator (page 5-20)
2000-Sheet Tray 6 Drive P/J Locator (page 5-21)
2000-Sheet Tray 6 Sensors Wiring (page 5-24)
2000-Sheet Tray 6 Drive Wiring (page 5-25)
PL22.4 Tray 6 Feeder (1/3) (page 4-24)
PL22.5 Tray 6 Feeder (2/3) (page 4-26)
PL22.6 Tray 6 Feeder (3/3) (page 4-28)
PL22.8 Tray 6 Electrical (page 4-32)
Phaser 5500 Printer Service Manual
Yes
Go to Step 2.
Go to Step 10.
Go to Step 4.
Go to Step 6.
Go to Step 6.
No
Clean or replace
the Rollers.
Go to Step 3.
Connect and go
to Step 4.
Connect and go
to Step 5.
Problem solved.