Staple Set Over Count - Fuji Xerox Phaser 5500 Service Manual

Stapler Failure (Staple Head Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
7
Check Staple Harness connections.
Are P/J8356 and P/J8308 connected?
8 Cycle the printer power.
Does the error still occur?
9 Check Staple Harness continuity.
1. Disconnect P/J8356 and P/J8308.
2. Check for continuity at the following:
P/J8356-1 <=> P/J8308-15
P/J8356-2 <=> P/J8308-14
P/J8356-3 <=> P/J8308-13
P/J8356-4 <=> P/J8308-12
P/J8356-5 <=> P/J8308-11
Are these conductive?
10 Check for +5 V to the Staple Assembly.
Is there +5 V across J8308-11 <=>
J8308-15 on the Finisher Main PWB?
11 Replace the Stapler Assembly.
Does the error still occur?
12 Replace the Finisher Main PWB.
Does the error still occur?

Staple Set Over Count

The Stacker Lower Tray set count has reached its limit.
Staple Set Over Count Troubleshooting Reference
Applicable Parts
Finisher Main
PWB
Engine Logic
Board
Staple Set Over Count Troubleshooting Procedure
Step Actions and Questions
1 Check the Finisher Main PWB.
Are all the connectors connected to the
Finisher Main PWB?
Error Messages, Codes, and Procedures
References
Finisher Main PWB P/J Locator (page 5-35)
PL8.1 Print Engine Electrical (page 9-40)
PL25.14 Finisher Electrical (page 4-70)
Yes
Go to Step 9.
Go to Step 9.
Go to Step 10.
Go to Step 11.
Go to Step 12.
Replace the
Engine Logic
Board
(page 8-89).
Yes
Go to Step 3.
No
Connect and go
to Step 8.
Problem solved.
Repair the Staple
Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
Problem solved.
No
Connect and go
to Step 2.
3-229