Fuji Xerox Phaser 5500 Service Manual page 258

Eject Clamp (Set Clamp Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
7 Check the Set Clamp Home Sensor signal.
Does the voltage across P8302B-11<=>
P8302B-9 on the Finisher Main PWB
change when the sensor is blocked?
8 Test the Eject Motor.
Run the Service Diagnostics Low Speed
Forward and Reverse Eject Motor tests.
Does the Eject Motor rotate normally?
9 Check Eject Motor Harness connections.
Are P/J8336 and P/J8304 connected?
10 Print a Test Print.
Does the error still occur?
11 Check Eject Motor Harness continuity.
1. Disconnect P/J8336 and P/J8304.
2. Check for continuity at the following:
P/J8336-1 <=> P/J8304-15
P/J8336-2 <=> P/J8304-12
P/J8336-3 <=> P/J8304-17
P/J8336-4 <=> P/J8304-19
P/J8336-5 <=> P/J8304-14
P/J8336-6 <=> P/J8304-21
Are these conductive?
12 Check Eject Motor resistance.
Is there resistance across P8336-2/
5(COM) and P8336-1/3/4/6?
13 Check for +24 V to the Eject Motor.
Is there +24 V across J8304-12 <=>
ground, and J8304-14 <=> ground on
the Finisher Main PWB?
14
Replace the Eject Clamp Motor.
Print a Test Print.
Does the error still occur?
15 Test the Set Clamp Clutch (Clutch Z34).
Run the Service Diagnostics Set Clamp
Clutch test.
Does the Set Clamp Clutch operate?
16
Check the Set Clamp Clutch Harness
connection.
Are P/J8338B and P/J8304 connected?
17
Print a test Print.
Does the error still occur?
3-180
Yes
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 15.
Go to Step 11.
Go to Step 11.
Go to Step 12.
Go to Step 13.
Go to Step 14.
Replace the
Finisher Main
PWB
(page 3-248).
Replace the
Finisher Main
PWB
(page 3-248).
Go to Step 18.
Go to Step 18.
Phaser 5500 Printer Service Manual
No
Replace the Set
Clamp Home
Sensor
(page 3-188).
Go to Step 9.
Connect and go
to Step 10.
Problem solved.
Repair the Eject
Motor Harness.
Replace the Eject
Bracket Assembly
(page 3-187).
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.
Go to Step 16.
Connect and go
to Step 17.
Problem solved.