Resolution - Fuji Xerox Phaser 5500 Service Manual

Damaged Print Troubleshooting Procedure (Continued)
Step Actions and Questions
2 Check paper feeding.
1. Remove the source Tray.
2. Reload paper in the tray.
3. Print a Test Print.
Does the problem still occur?
3 Check paper condition.
1. Load new, dry paper.
2. Print a Test Print.
Does the problem still occur?
4 Check the paper path.
Is the paper path clear?
5
Check rollers in the paper path.
1. Check Feed and paper path
rollers for contamination, wear, or
damage.
2. Check whether pinch rollers rotate
freely and spring pressure is
applied evenly.
Is there any contamination, wear
or damage to the rollers?
6
Check the Heat and Pressure Roller.
WARNING:
Remove the Fuser.
Is there contamination or defects
on the Heat or Pressure Roller?
7 Replace the following, in order, until
the defective component is found.

Resolution

The two pixel lines and halftone patches cannot be reproduced clearly on the test
print.
Initial Actions
Ensure the NVRAM Laser Power adjustment is set to the default, which is 4.
5-34
Allow the Fuser to cool
before removing it.
Paper Feed Rollers
Fuser (page 8-76)
Transfer Roller (page 8-44)
Exit Assembly (page 8-78)
Yes
Go to Step 3.
Go to Step 4.
Go to Step 5.
Replace defective
rollers.
Replace the Fuser
(page 8-76).
Phaser 5500 Printer Service Manual
No
Problem solved.
Problem solved.
Remove obstacles or
contamination.
Go to Step 6.
Go to Step 7.