Face Down Tray Paper Full - Face Down Tray Full - Fuji Xerox Phaser 5500 Service Manual

Temp/Humidity Sensor Failure (Environmental PWB) Troubleshooting Procedure
Step Actions and Questions
2 Check continuity between the sensor and
the Engine Logic Board.
1. Disconnect P/J403 and P/J150.
2. Check for continuity at the following:
P/J403-B15 <=> P/J150-1
P/J403-B7 <=> P/J150-2
P/J403-B4 <=> P/J150-3
P/J403-B6 <=> P/J150-4
Are these conductive?
3 Check for +5 V to the sensor.
Is there +5 V across P/J403-15 <=> and
P/J403-4?

Face Down Tray Paper Full - Face Down Tray Full

The Full Stack Sensor on Exit 1 or Exit 2 indicates a Stack Full condition for the
Standard Output Tray.
Standard Output Tray Full (Exit Full Stack Sensor) Troubleshooting Reference
Applicable Parts
Exit PWB
Engine Logic
Board
Full Stack
Actuator Link
Full Stack
Actuator
Full Stack Sensor
Standard Output Tray Full (Exit Full Stack Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the actuator installation on the
affected Exit.
Does the Actuator move normally and
pass through the sensing area?
3-220
References
Print Engine P/J Laser and Exit PWB (page 10-7)
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Exit 1 Wiring (page 10-30)
PL6.2 Exit 1 (page 9-36)
PL8.1 Print Engine Electrical (1/2)
Phaser 5500 Printer Options Service Manual
Exit 2 P/J Locator (page 5-15)
Exit 2 Sensor/Fan Wiring (page 5-18)
PL24.2 Exit 2 (page 4-40)
Phaser 5500 Printer Service Manual
Yes
Go to Step 3..
Replace the
Environmental
PWB (page 8-64)
If the error
persists, replace
the Engine Logic
Board
(page 8-89).
Yes
Go to Step 2.
No
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).
No
Correct the
installation.