Jam At Tray N - Registration - Fuji Xerox Phaser 5500 Service Manual

Jam at Tray n - Registration

Paper fed from a universal tray did not reach the Registration Sensor on time.
Applicable Error Codes
Jam at Tray 2 - C1-3 Tray 2
Jam at Tray 3 - C2-3 Tray 3
Jam at Tray 4 - C3-3 Tray 4
Jam at Tray 5 - C4-3 Tray 5
Jam at Tray n (Registration Sensor) Troubleshooting Reference
Applicable Parts
Feed Roller
Retard Roller
Nudger Roller
Registration Sensor
Tray 2 Pre-Feed Sensor
Tray 3 Pre-Feed Sensor
Engine Logic Board
Tray 4-5 PWB
Tray 4 Feed Out Sensor
Tray 5 Feed Out Sensor
Jam at Tray n (Registration Sensor) Troubleshooting Procedure
Step Actions and Questions
1
Check paper condition.
Is the paper in the tray damaged?
2 Check paper size settings.
Does the paper size in use match the
setting for the tray?
3 Remove the tray and check the rollers.
Is the Feed, Retard, or Nudger Roller
worn or contaminated with paper dust?
4 Check paper position at Door A or B.
Does the paper touch the Registration
Sensor or Feeder's Pre-Feed Sensor?
5 Test the Registration Sensor.
1. Open Door A.
2. Run the Service Diagnostics
Registration Sensor test.
Does the sensor change state?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Tray 2 & 3 Wiring (page 10-26)
PL2.3 Feeder (2/2) (page 9-12)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet Feeder P/J Locator (page 5-5)
1000-Sheet Tray 4 & 5 Wiring (page 5-9)
PL20.4 Tray 4-5 Feeders (2/2) (page 4-10)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Yes
Replace the
paper.
Go to Step 3.
Clean or replace
the Rollers.
Remove the
paper.
Go to Step 9.
No
Go to Step 2.
Correct paper
size settings.
Go to Step 4.
Go to Step 5.
Go to Step 6.
3-59