Stacker Lower Tray Failure - H5-11 Low Tray Fail - Fuji Xerox Phaser 5500 Service Manual

Finisher Board Error (NVRAM R/W Error) Troubleshooting Procedure (Continued)
Step Actions and Questions
4 Check continuity between the Finisher
Main PWB and the Engine Logic Board.
1. Disconnect P/J8300 and P/J416.
2. Check for continuity at the following:
P/J8300-11 <=> P/J416-1
P/J8300-10 <=> P/J416-2
P/J8300-9 <=> P/J416-3
P/J8300-8 <=> P/J416-4
P/J8300-7 <=> P/J416-5
P/J8300-6 <=> P/J416-6
P/J8300-4 <=> P/J416-7
P/J8300-3 <=> P/J416-8
P/J8300-2 <=> P/J416-9
P/J8300-1 <=> P/J416-10
P/J8300-4 <=> P/J416-11
Are these conductive?
5 Check for +24 V to the Finisher Main PWB.
Is there +24 V across J416-6 (+) <=>
ground?

Stacker Lower Tray Failure - H5-11 Low Tray Fail

The Lower Tray No Paper Sensor is not turned Off or On within the specified time
following the Stacker Tray beginning to move.
Applicable Error Code
Stacker Lower Tray Failure - H5-11 Low Tray Fail
Stacker Lower Tray Failure (Stack Height Sensors) Troubleshooting Reference
Applicable Parts
Lower Tray No Paper
Sensor
Upper Limit Actuator
Finisher Main PWB
Main Sensor Harness
Elevator Motor
Engine Logic Board
3-160
Yes
Go to Step 4.
Replace the
Finisher Main
PWB
(page 3-248).
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (2/2) Wiring (page 5-41)
Finisher Clutch and Solenoids (page 5-43)
PL25.6 Finisher Stack (page 4-54)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Phaser 5500 Printer Service Manual
No
Repair the wiring.
Replace the
Engine Logic
Board
(page 8-89).