Fuji Xerox Phaser 5500 Service Manual page 126

E4-6 Exit 2 Area Jam Troubleshooting Reference
Applicable Parts
Exit 2 Exit Sensor
Exit PWB
Engine Logic Board
LVPS
E4-6 Exit 2 Area Jam Troubleshooting Procedure
Step Actions and Questions
1 Check paper position at Door A.
Is paper touching the Fuser Exit
Sensor?
2 Test the Exit Sensor.
Run the Service Diagnostics Exit Sensor
test.
Does the sensor change state?
3 Check the Exit Sensor connection.
Are P/J112, P/J606B and P/J434
connected?
4
Check continuity between the Exit Sensor
and Exit PWB.
Is there continuity on each wire
between P/J112<=> P/J434?
5
Check for +5 V at the Exit Sensor.
Is there +5 V across the sensor
connector's P/J112-3 <=> ground?
6
Check the connection between the Exit
PWB and Engine Logic Board.
Are P/J431 and P/J421 connected?
7
Check continuity between the Exit PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J431 <=> P/J421?
8 Check the connection between Exit PWB
and LVPS.
Are P/J430 and P/J526 connected?
3-48
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine P/J Laser and Exit PWB (page 10-7)
Print Engine Exit 1 Wiring (page 10-30)
Phaser 5500 Printer Options Service Manual
Exit 2 Plug/Jack Locator (page 5-15)
Exit 2 General Wiring (page 5-7)
PL8.1 Print Engine Electrical (page 9-40)
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
Phaser 5500 Printer Service Manual
Yes
Remove the
paper.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 4.
Go to Step 5.
Replace the Exit
Sensor
(page 3-102).
Go to Step 7.
Go to Step 8.
Go to Step 9.
No
Go to Step 2.
Go to Step 3.
Connect the
sensor.
Repair the wiring.
Go to Step 6.
Connect P/J431
and P/J421.
Repair the wiring.
Connect P/J430
and P/J526.