Fuser Fan - Fuji Xerox Phaser 5500 Service Manual

Fuser Fan

1.
Remove the I/P Board Cover (page 8-14).
2.
Remove the Upper Rear Cover (page 8-15).
PL5.1.13
3. Disconnect the Fan connector from the Motor Assembly.
4. Release the hooks left and right securing the Fan to the duct as shown and remove
the Fan.
Replacement Note
Install the Fan with the label facing outward. Also, route the Fan harness in
the slot as shown in the figure.
FRU Disassembly
Hooks
Motor Assembly
Fuser Fan
Label
CN102
CN102
s5500-163
8-59