Jam At Tray 6 - C5-2 Tray 6 - Fuji Xerox Phaser 5500 Service Manual

Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Procedure (Continued)
Step Actions and Questions
24
Test for +24 V at the Nudger Solenoid.
Run the Service Diagnostics Tray 6 Nudger
Solenoid Test at High Power.
Is the voltage across PF06-13 <=>
P/JF04-3 on the PWB, +24 V?
25 Test for +14.7 V at the Nudger Solenoid.
Run the Service Diagnostics Tray 6 Nudger
Solenoid Test at Low Power.
Is the voltage across PF06-13 <=>
P?JF04-3 on the PWB, +14.7V?
26 Replace the Nudger Solenoid.
Print a Test Print
Does the error still occur?
27 Replace the Tray 6 PWB.
Print a Test Print
Does the error still occur?

Jam at Tray 6 - C5-2 Tray 6

Paper fed from the 2000-Sheet Feeder did not reach the Tray 3 Feed Out Sensor #3,
located behind Door B, on time.
Applicable Error Code
Jam at Tray 6 - C5-2 Tray 6
Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Reference
Applicable Parts
Feed Roller
Nudge Roller
Retard Roller
Take Away Roller
Door J
Feed Out Sensor
Feeder Harness
Main Harness
Tray 6 PWB
Take Away Motor
Engine Logic Board
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
2000-Sheet Tray 6 Feeder P/J Locator (page 5-20)
2000-Sheet Tray 6 Drive P/J Locator (page 5-21)
2000-Sheet Tray 6 Sensors Wiring (page 5-24)
2000-Sheet Tray 6 Drive Wiring (page 5-25)
PL22.5 Tray 6 Feeder (2/3) (page 4-26)
PL22.6 Tray 6 Feeder (3/3) (page 4-28)
PL22.7 Drive and Transportation (page 4-30)
PL22.8 Tray 6 Electrical (page 4-32)
Yes
Go to Step 25.
Go to Step 26.
Go to Step 27.
Replace the
Engine Logic
Board
(page 8-89).
No
Replace the Tray
6 PWB
(page 3-67).
Replace the Tray
6 PWB
(page 3-67).
Problem Solved.
Problem solved.
3-71