Stacker Lower Tray Failure - H5-2N Rear Home Snr - Fuji Xerox Phaser 5500 Service Manual

Tamper (Front Tamper Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions
11 Check Compiler Front Tamper Motor
Harness continuity.
1. Disconnect P/J8363B and P/J8309.
2. Check for continuity at the following:
P/J8363B-6 <=> P/J8309-10
P/J8363B-5 <=> P/J8309-11
P/J8363B-4 <=> P/J8309-12
P/J8363B-3 <=> P/J8309-13
P/J8363B-2 <=> No connection
P/J8363B-1 <=> P/J8309-14
Are these conductive?
12
Check for +24 V to the Front Tamper Motor.
Is there +24 V across J8309-11 <=>
ground on the Finisher Main PWB?
13 Replace the Front Tamper Motor.
Print a Test Print.
Does the error still occur?

Stacker Lower Tray Failure - H5-2n Rear Home SNR

For H-22, the Rear Tamper Home Sensor is not turned On within 800 ms following
the Rear Tamper beginning to move to the Rear Tamper Home position. For H5-24,
the Rear Tamper Home Sensor is not turned Off in the time specified following the
Rear Tamper leaving the home position, or the Rear Tamper Home Sensor is turned
On again after the Rear Tamper Home Sensor is turned Off and the Rear Tamper stops
moving.
Applicable Error Codes
Stacker Lower Tray Failure - H5-22 Rear Home SNR ON
Stacker Lower Tray Failure - H5-24 Rear Home SNR OFF
Tamper (Rear Tamper Home Sensor) Troubleshooting Reference
Applicable Parts
Rear Tamper Home
Sensor
Compiler Tray Assembly
Compiler Harness
Finisher Main PWB
Rear Tamper Motor
3-170
Yes
Go to Step 12.
Go to Step 13.
Replace the
Finisher Main
PWB
(page 3-248).
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Compiler P/J Locator (page 5-33)
Finisher Compiler Tray Wiring (page 5-44)
PL25.10 Finisher Eject (2/3) (page 4-62)
PL25.14 Finisher Electrical (page 4-70)
Phaser 5500 Printer Service Manual
No
Repair the
Compiler Front
Tamper Motor
Harness.
Replace the
Finisher Main
PWB
(page 3-248).
Problem solved.