Jam At G - F4-4N Buffer Path Snr On - Fuji Xerox Phaser 5500 Service Manual

Jam at G - F4-4n Buffer Path SNR ON

Paper does not reach the Buffer Path Sensor in time following the paper's leading
edge reaching the Finisher's Transport Entrance Sensor.
Applicable Error Codes
Jam at G - F4-42 Buffer Path SNR ON Jam A
Jam at G - F4-43 Buffer Path SNR ON Jam B
Jam at G (Buffer Path Sensor ON) Troubleshooting Reference
Applicable Parts
Entrance Roller
Entrance Pinch Roller
Buffer Roller
Pinch Roller
Entrance Sensor Harness
Main Sensor Harness
Finisher Main PWB
X'port Entrance Sensor
Main Drive Harness
Transport Motor
X'port Gate Sensor
Sensor Harness
Buffer Gate Solenoid
Registration Motor
Buffer Sensor Harness
Buffer Path Sensor
Jam at G (Buffer Path Sensor ON) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
1. Open Door G.
2. Remove the Top Cover.
3. Remove the Top L/H Cover.
4. Open the Upper Entrance Chute.
Are the Rollers attached to the Chute
clean, roll freely, and correctly
installed?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
Finisher Clutch and Solenoids (page 5-43)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 2.
No
Clean or replace
the appropriate
roller.
3-101