Fuji Xerox Phaser 5500 Service Manual page 257

Eject Clamp (Set Clamp Home Sensor) Troubleshooting Reference
Applicable Parts
Set Clamp Home
Sensor
Main Sensor Harness
Finisher Main PWB
Eject Bracket
Assembly
Main Drive Harness
Set Clamp Clutch
Eject Clamp (Set Clamp Home Sensor) Troubleshooting Procedure
Step Actions and Questions
1 Check the Eject Clamp operation.
Rotate the Eject Clamp Motor.
Does the Eject Clamp move smoothly?
2 Test the Set Clamp Home Sensor.
Run the Service Diagnostics Set Clamp
Home Sensor test.
Does the sensor change state?
3 Check the Set Clamp Home Sensor
Harness connection.
Are P/J8325 and P/J8302B connected?
4 Print a Test Print.
Does the error still occur?
5
Check the Set Clamp Home Sensor
Harness continuity.
1. Disconnect P/J8325 and P/J8302B.
2. Check for continuity at the following:
P/J8325-3 <=> P/J8302B-4
P/J8325-2 <=> P/J8302B-9
P/J8325-1 <=> P/J8302B-11
Are these conductive?
6
Check for +5 V to the Set Clamp Home
Sensor.
Is there +5 V across J8302B-11 <=>
J8302B-9 on the Finisher Main PWB for
H5-83?
Is there +5 V across J8302B-4 <=>
J8302B-9 on the Finisher Main PWB for
H5-84?
Error Messages, Codes, and Procedures
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Compiler P/J Locator (page 5-33)
Finisher Sensors (2/2) Wiring (page 5-41)
Finisher Clutch and Solenoids Wiring (page 5-43)
PL25.10 Finisher Eject (2/3) (page 4-62)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 2.
Go to Step 8.
Go to Step 5.
Go to Step 5.
Go to Step 6.
Go to Step 7.
No
Correct the
installation.
Go to Step 3.
Connect and go
to Step 4.
Problem solved.
Repair the Set
Clamp Home
Sensor Harness.
Replace the
Finisher Main
PWB
(page 3-248).
3-179