Jam At F Or G - F4-5N Compile Exit Snr On - Fuji Xerox Phaser 5500 Service Manual

Jam at F or G - F4-5n Compile Exit SNR ON

Paper does not reach the Compile Exit Sensor on time.
Applicable Error Codes
Jam at F - F4-52 Compile Exit SNR ON Jam A
Jam at G - F4-53 Compile Exit SNR ON Jam B
Jam at G - F4-54 Compile Exit SNR ON Jam C
Jam at F or G (Compile Exit Sensor ON) Troubleshooting Reference
Applicable Parts
Buffer Roller
Pinch Roller
Exit Pinch Roller
Buffer Sensor Harness
Main Sensor Harness
Finisher Main PWB
Buffer Path Sensor
Main Drive Harness
Registration Motor
Compiler Harness
Compile Exit Sensor
Jam at F or G (Compile Exit Sensor ON) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
1. Open Door G.
2. Open the Upper Exit Chute (2A).
3. Open the Bottom Buffer Chute (3).
Are the Buffer and Pinch Rollers
attached to the chutes clean, roll freely,
and correctly installed?
2 Test the Buffer Path Sensor.
Run the Service Diagnostics Buffer Path
Sensor test.
Does the sensor state change?
3 Check the Buffer Path Sensor connection.
Are P/J8392 and P/J8318 connected?
4 Print a Test Print.
Does the error still occur?
5 Check Main Sensor Harness connections.
Are P/J8318 and P/J8302A connected?
3-112
References
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (1/2) Wiring (page 5-40)
Finisher Motors Wiring (page 5-42)
PL25.10 Finisher Eject (2/3) (page 4-62)
PL25.11 Finisher Eject (3/3) page 4-64)
PL25.12 Finisher Transport (1/2) (page 4-66)
PL25.13 Finisher Transport (2/2) (page 4-68)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Yes
Go to Step 3.
Go to Step 11.
Go to Step 5.
Go to Step 5.
Go to Step 7.
Phaser 5500 Printer Service Manual
No
Clean or replace
the appropriate
roller.
Go to Step 3.
Connect and go
to Step 4.
Problem solved.
Connect and go
to Step 5.