Messages, Codes, And Procedures; Error Message Abbreviations - Fuji Xerox Phaser 5500 Service Manual

Messages, Codes, and Procedures

The error messages and codes generated by the printer's operating system, the Service
Usage Profile, and Service Diagnostics are the lead-in to the troubleshooting
procedures that follow in subsequent pages. This section correlates the output of these
three diagnostic aids and provides the troubleshooting procedure to locate and correct
reported errors.

Error Message Abbreviations

Due to limited display space, some error messages include abbreviations. The most
common abbreviations used throughout this chapter are listed here.
Error Message Abbreviations
Term Definition
Reg or REGI Registration
SNR Sensor
DUP or DM Duplex Unit
F/O Feed Out
T/A Take Away
H-Xport Horizontal Transport
MCU Main Control Unit
I/P Board Image Processor
OCT Offset Catch Tray
HCF High-Capacity Feeder
MSI or MPT Multi-Sheet Input
IOT Image Output Terminal
2TM Two-tray Module
P/J Plug/Jack
EM Exit Module
SW Switch
NVM Non-volatile Memory
CRUM Customer-Replaceable
Unit Monitor
Comm Communication
LVPS Low-Voltage Power Supply Primary power supply.
PWB Printed Wire Board
3-14
Comment
Used in designators such as Reg SNR.
Often seen as SNR1 or Reg SNR.
Optional for 2-sided printing.
Used as sensor designators F/O1 or F/O #2.
Function designator for roller or motor.
Horizontal Transport section of the Finisher.
Engine Logic Board
Image Processor Board
Offset Rollers at Exit
Option Tray 6 or 2000-Sheet Feeder
Used to describe Tray 1/MPT.
Used instead of printer.
Option Trays 4 and 5 or 1000-Sheet Feeder
Plug (P) and or Jack (J) designators
Used for either Exit (1 or optional Exit 2).
Appears as a designator.
Used instead of NVRAM.
Device used to store usage information on the
Drum and Toner Cartridges.
As in MCU-DM Comm Error.
Used to describe a circuit board (Tray 6 PWB).
Phaser 5500 Printer Service Manual