Jam At C - C8-4 F/O5 Snr Static Jam - Fuji Xerox Phaser 5500 Service Manual

Jam at C (Feed Out Sensor #4) Troubleshooting Procedure (Continued)
Step Actions and Questions
7 Check +5 V to the Tray 4-5 PWB
Is there +5 V across P/J541-8 (+) <=>
ground?

Jam at C - C8-4 F/O5 SNR Static Jam

Paper remains at Feed Out Sensor (F/O#5) located behind Door C.
Applicable Error Code
Jam at C - C8-4 F/O5 SNR Static Jam
Jam at C (Feed Out Sensor #5) Troubleshooting Reference
Applicable Parts
Feed Out Sensor #5
Tray 4-5 PWB
Engine Logic Board
Jam at C (Feed Out Sensor #5) Troubleshooting Procedure
Step Actions and Questions
1 Check the paper path.
Open Door C.
Does the paper touch Feed Out
Sensor #5?
2 Test Feed Out Sensor #5.
Run the Service Diagnostics Tray 5 Feed
Out Sensor test.
Does the sensor change state?
3
Check the Feed Out Sensor #5 connection.
Are P/J825, P/J842, and P/J548
connected?
4
Check continuity between the Feed Out
Sensor #5 and Tray 4-5 PWB.
Is there continuity on each wire
between P/J825 <=> P/J548?
3-78
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
1000-Sheet P/J Tray 4 & 5 Feeders (page 5-5)
1000-Sheet P/J Tray 4 & 5 Electrical (page 5-6)
1000-Sheet Tray 4 Wiring (page 5-9)
PL20.5 Tray 4-5 Transportation (page 4-14)
PL20.6 Tray 4-5 Drive and Electrical (page 4-16)
Phaser 5500 Printer Service Manual
Yes
Replace the Tray
4-5 PWB
(page 3-29).
Yes
Remove the
paper.
Replace the
Engine Logic
Board
(page 8-89).
Go to Step 4.
Go to Step 5.
No
Replace the
Engine Logic
Board
(page 8-89).
No
Go to Step 2.
Go to Step 3.
Connect the
sensor.
Repair the wiring.