Fuji Xerox Phaser 5500 Service Manual page 123

E4-3 Exit 2 Area Jam Troubleshooting Reference
Applicable Parts
Exit 2 Exit Sensor
Exit 2 Motor
Exit 2 OCT Roller
Exit 2 FU Roller
Exit 2 Inv Roller
Exit PWB
Engine Logic Board
LVPS
E4-3 Exit 2 Area Jam Troubleshooting Procedure
Step Actions and Questions
1 Check paper position at Door E.
Is paper touching the Exit 2 Sensor?
2 Check the FU Roller.
Is the FU Roller worn or contaminated
with paper dust?
3
Check the drive transmission.
Does the FU Roller and gears rotate
smoothly?
4
Check the Inv Roller.
Is the INV Roller worn or contaminated
with paper dust?
5
Check the drive transmission.
Does the INV Roller and gears rotate
smoothly?
6
Check the OCT Roller.
Is the OCT Roller worn or contaminated
with paper dust?
7 Check the drive transmission.
Does the OCT Roller and gears rotate
smoothly?
8 For E4-5 Only:
Test Exit 2 Gate Solenoid.
Run the Service Diagnostics Exit 2 Gate
Solenoid test.
Does the Solenoid operate the Gate?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
Print Engine Exit 1 Wiring (page 10-30)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Exit 2 Plug/Jack Locator (page 5-15)
Exit 2 General Wiring (page 5-7)
PL24.1 Exit 2 L/H Upper Chute (page 4-38)
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
Yes
Remove the
paper.
Clean or replace
the FU Roller.
Go to Step 4.
Clean or replace
the INV Roller.
Go to Step 6.
Clean or replace
the OCT Roller.
For E4-5: Go to
Step 8.
For E4-3: Go to
Step 9.
Got to Step 9.
No
Go to Step 2.
Go to Step 3.
Restore proper
operation.
Go to Step 5.
Restore proper
operation.
Go to Step 7.
Restore proper
operation.
Go to Step 10.
3-45