Jam At B - C5-3 Tray 6 - Fuji Xerox Phaser 5500 Service Manual

Jam at Tray 6 (Feed Out Sensor #6) Troubleshooting Procedure (Continued)
Step Actions and Questions
11
Check the Main Harness connections.
Are the connectors PF57 and P/JF06 on
the Main Harness connected?
12 Print a Test Print.
Does the error still occur?
13 Check the Feeder Harness for continuity
1. Disconnect PF57 and JF06.
2. Check for continuity at the following:
PF57-7 <=> P/JF06-11
PF57-6 <=> P/JF06-8
PF57-5 <=> P/JF06-9
PF57-4 <=> P/JF06-10
PF57-3 <=> P/JF06-12
PF57-2 <=> P/JF06-7
Are these conductive?
14 Check Take Away Motor resistance.
Is there some amount of resistance
across F57-3/4(COM) and JF57-1/2/5/6?
15 Check for +24 V at the Take Away Motor.
Is there +24 V across PF06-9 <=> PF04-
2, and PF06-10 <=> PF04-2 on the Tray 6
PWB?
16 Replace the Take Away Motor.
Print a Test Print.
Does the error still occur?
17 Replace the Tray 6 PWB.
Print a Test Print
Does the error still occur?

Jam at B - C5-3 Tray 6

Paper fed from the 2000-Sheet Feeder did not reach the Print Engine's Registration
Sensor on time.
Applicable Error Code
Jam at B - C5-3 Tray 6
Error Messages, Codes, and Procedures
Yes
Go to Step 12.
Go to Step 13.
Go to Step 14.
Go to Step 15.
Go to Step 16.
Go to Step 17.
Replace the
Engine Logic
Board
(page 8-89).
No
Connect and go
to Step 12.
Problem solved.
Repair the Tray 6
Main harness.
Replace the Take
Away Motor
(page 3-64).
Replace the Tray
6 PWB
(page 3-67).
Problem solved.
Problem solved.
3-73