Stacker Lower Tray Failure - H5-12 Low Tray Upper Limit - Fuji Xerox Phaser 5500 Service Manual

Stacker Lower Tray Failure (Stack Height Sensors) Troubleshooting Procedure
Step Actions and Questions
11 Print a Test Print.
Does the error still occur?
12 Replace the Elevator Motor.
Print a Test Print.
Does the error still occur?
13 Replace the Finisher Main PWB.
Does the error still occur?
Stacker Lower Tray Failure - H5-12 Low Tray Upper
Limit
The Stacker Lower Tray rose beyond the upper limit position.
Applicable Error Codes

Stacker Lower Tray Failure - H5-12 Low Tray Upper Limit

Stacker Lower Tray Failure (Upper Limit Sensor) Troubleshooting Reference
Applicable Parts
Lower Tray No Paper
Sensor
Lower Tray Upper Limit
Sensor
Upper Limit Actuator
Finisher Main PWB
Main Sensor Harness
Elevator Motor
Engine Logic Board
Stacker Lower Tray Failure (Upper Limit Sensor) Troubleshooting Procedure
Step Actions and Questions
1
Check the Stacker Lower Tray vertical
transport and belts for obstacles and
deformation.
Are there obstacles or belt wear in the
vertical transport mechanism?
3-162
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Finisher Main PWB P/J Locator (page 5-35)
Finisher Sensors (2/2) Wiring (page 5-41)
Finisher Clutch and Solenoids (page 5-43)
PL25.6 Finisher Stack (page 4-54)
PL25.14 Finisher Electrical (page 4-70)
PL25.15 Finisher Harness (page 4-72)
Phaser 5500 Printer Service Manual
Yes
Go to Step 12.
Go to Step 13.
Replace the
Engine Logic
Board
(page 8-89).
Yes
Remove any
obstacles.
No
Problem solved.
Problem solved.
Problem solved.
No
Go to Step 2.