Jam At A - F4-12 H-X'port Ent. Snr On - Fuji Xerox Phaser 5500 Service Manual

Jam at A - F4-12 H-X'port Ent. SNR ON

Paper leaving the printer activated the printer's Fuser Exit Sensor but did not reach the
Horizontal Transport Entrance Sensor on time.
Applicable Error Code
Jam at A - F4-12 H-X'port Ent. SNR ON
Jam at A (H-X'port Entrance Sensor) Troubleshooting Reference
Applicable Parts
H-X'port Belts
H-X'port Pinch Rollers
H-X'port Motor
H-X'port Harness
H-X'port Entrance
Sensor
Finisher H-X'port PWB
Finisher Main PWB
Engine Logic Board
Jam at A (H-X'port Entrance Sensor) Troubleshooting Procedure
Step Actions and Questions
1
Check the paper path.
Open Door F.
Are the Belts and Pinch Rollers clean,
operate freely, and correctly installed?
2 Test the H-'Xport Entrance Sensor.
1. Open Door F.
2. Run the Service Diagnostic H-'Xport
Entrance Sensor test.
Does the sensor change state?
3
Check the H-'Xport Harness connections.
Is the harness connected to the H-
X'port Entrance Sensor and Finisher
correctly?
4
Print a Test Print.
Does the error still occur?
Error Messages, Codes, and Procedures
References
Print Engine P/J Engine Logic Board (page 10-13)
PL8.1 Print Engine Electrical (page 9-40)
Phaser 5500 Printer Options Service Manual
Horizontal Transport P/J Locator (page 5-29)
Horizontal Transport Wiring (page 5-39)
Finisher Main PWB P/J Locator (page 5-35)
PL25.2 Horizontal Transport (1/2) (page 4-46)
PL25.3 Horizontal Transport (2/2) (page 4-48)
PL25.14 Finisher Electrical (page 4-70)
Yes
Go to Step 2.
Go to Step 8.
Go to Step 5.
Go to Step 5.
No
Clean or replace
affected
components.
Go to Step 3.
Reconnect and
go to Step 4.
Problem solved.
3-87